EasyManuals Logo

Alcatel OmniPCX Office Technical Documentation

Alcatel OmniPCX Office
964 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #428 background imageLoading...
Page #428 background image
IMPLEMENTING 4073 GS SMART
HANDSETS
CALL SERVER : MOBILITY
Ed. 042/8 Réf. 3EH 21000 BSAA
REGISTERING THE HANDSET
For new handsets, the battery included is factory pre-charged; the level of charge is sufficient to register
the terminal. Fit the battery into the handset and check that the level of charge is adequate (full or half-
charge icon); if not, put it on the charge base.
Start the registration procedure on the PABX. When the system is ready, continue with the handset.
Step A
Long press on i to turn on the handset.
If the set is new (never been assigned) and has enough battery charge, the display shows "Auto install
system 1-OK ? ", there are two possibilities:
- if the installation doesnt use the authentication function (AC code), go directly to step C for the
simplified procedure
- if the system uses an authentication code, press briefly on the "On-hook" key, and move
on to step B.
If the set does not display "Auto install system 1-OK ? " (it is already assigned on another system), go
to step B.
Step B
Long press on '#', for enter in the handset's local menu.
Press briefly on 't', to enter the 'System' sub-menu.
Press briefly on 'OK' to enter the 'Install' sub-menu.
Use the navigator to select a free position for the system to occupy (1, 2 or 3).
Press briefly on 'OK' to validate.
Enter the AC code, if the system uses one; otherwise go to step C.
Step C
Press briefly on 'OK' to validate and launch the registration request
When the set identifier appears on the MMC system window, validate the entry to complete the ope-
ration. Registration becomes effective once the set has been turned on and off, or after an outgoing
call has been made (the call attempt will fail).

Table of Contents

Other manuals for Alcatel OmniPCX Office

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel OmniPCX Office and is the answer not in the manual?

Alcatel OmniPCX Office Specifications

General IconGeneral
VoIP SupportYes
SIP SupportYes
ISDN SupportYes
Analog SupportYes
Integrated Voice MailYes
Auto AttendantYes
ConferencingYes
VoIP ProtocolsSIP, H.323
Power Supply100-240 VAC, 50/60 Hz
Network Interfaces10/100 Mbps Ethernet
Humidity10% to 90% non-condensing