File
8
POINT TO POINT / POINT TO
MULTIPOINT T0
APPLICATIONS
Ed. 04 3/4Réf. 3EH 21000 BSAA
T Fill in the public numbering plan:
T0 configured in Point to Multipoint
- To configure the T0 access in Point to Multipoint:
- To define the management mode:
- For fixed TEI, assign a value between 0 and 63 inclusive:
- Configuring the installation number:
- Completing the substitution table (refer to the file concerning DDI with more than 4 digits in the
"System Features" section):
- Fill in the public numbering plan:
- by MMC-PM5 (Expert View): Numbering -> Numbering Plans -> Public Numbering Plan
- by MMC-Station: NumPln -> PubNum
By MMC-PM5 (Expert View), select: External Lines -> List of Accesses -> Details -> select o Point
to Multipoint
By MMC-PM5 (Expert View), select: External Lines -> List of Accesses -> Details -> select o Fixed
TEI or o Auto TEI
By MMC-PM5 (Expert View), select: External Lines -> List of Accesses -> Details -> Value
- by MMC-PM5 (Expert View): Numbering -> Installation Number
- by MMC-Station: Global -> Ins Num -> Public
- by MMC-PM5 (Expert View): Numbering -> DDI Number Modification Table
- by MMC-Station: Num Pln -> PubNMT
- by MMC-PM5 (Expert View): Numbering -> Numbering Plans -> Public Numbering Plan
- by MMC-Station: NumPln -> PubNum
To Next Page
Loading...
