5-1
5
How to Operate BERT
Chapter 5
How to Operate BERT
This chapter explains the BERT module setting items and how to
measure the bit error.
5.1
Procedure for Generating Pulse Signal ........................ 5-2
5.2
PPG/ED Panel .............................................................. 5-3
5.2.1
Setting Reference Clock ................................... 5-7
5.2.2
Setting Bit Rate ................................................. 5-8
5.2.3
Setting Patterns .............................................. 5- 10
5.2.4
Setting Output Waveform ............................... 5-13
5.2.5
Setting Sync Out ............................................. 5-14
5.2.6
Setting Clk Out ............................................... 5- 1 6
5.2.7
Inserting Bit Error ............................................ 5-17
5.2.8
Setting Error Detection Method ...................... 5-18
5.2.9
Setting ED Measurement Condition ............... 5-22
5.2.10
Measurement Result ...................................... 5-25
5.2.11
Saving Measurement Results ........................ 5-26
5.3
Setting Restrictions ..................................................... 5-28
To Next Page
Loading...
