Anritsu MP2110A BERTWave - Features

Chapter 1 Outline
1-16
1.3 Features
The MP2110A has the following features:

Bit error rate measurement and waveform monitoring up to 28.2 Gbit/s

Bit error rate measurement and waveform monitoring in one
instrument

4-channel simultaneous BER measurement, handy for CFP4 module
and QSFP module testing (MP2110A-014)

Accurate waveform monitoring using low residual jitter of 200 fs and
rms (typical value) (MP2110A-024)

For sampling oscilloscope:
EYE analysis in short time using high-speed sampling

Compatibility of remote commands with previous Anritsu measuring
instruments

One or both of the following clock recovery units can be installed to the
sampling oscilloscope:

MP2110A-054: 25.5 to 28.2 Gbaud

MP2110A-055: 25.5 to 28.9 and 51.0 to 58.0 Gbaud

MP2110A-095 for PAM4 (Pulse Amplitude Modulation) waveform
analysis

MP2110A-096 for jitter analysis from the waveform obtained by
Sampling Oscilloscope