Chapter 8 Maintenance
8-12
8.7 System Recovery Function
The MP2110A has system recovery function to restore data on the hard
disk to the factory shipment status. These functions can be used in the
event of system instability.
CAUTION
Fully understand the following and back up all necessary
data before performing a system recovery.
Executing system recovery restores the original
Windows factory settings, and reverts the data stored on
the C drive to the original factory state. All data such as
applications and updates subsequently added,
measurement conditions saved, measurement results,
and screen captures will therefore be deleted.
Data deleted by these functions cannot be restored.
The MX210000A BERTWave Control Software must be
re-installed if system recovery is performed. Before
performing system recovery, prepare the MX210000A
software installer for the version you are using.
8.7.1 For WES7
<Procedure>
1. Disconnect the MP2110A from the network if connected.
2. Connect the keyboard and mouse to the mainframe, and then turn
the MP2110A power On.
To Next Page
Loading...
