E-1
Appendix E
Bibliography
(1) IEC60825-1
Safety of laser products. Part 1: Equipment
classification, requirements and user's guide
(2) IEC61010-1
Safety requirements for electrical equipment for
measurement, control, and laboratory use - Part 1:General
requirements
(3) IEC61280-2-1
Fibre optic communication subsystem basic test
procedures - Part 2-1: Test procedures for digital systems - Receiver
sensitivity and overload measurement
(4) IEC61280-2-2
Fibre optic communication subsystem test procedures
- Part 2-2: Digital systems Optical eye pattern, waveform and
extinction ratio measurement
(5) IEC62150-2
Fibre optic active components and devices - Test and
measurement procedures - Part 2: ATM-PON transceivers
(6) IEEE Std 802.3-2015
IEEE Standard for Ethernet
(7) ISO/IEC 14165-115
Information technology - Fibre channel - Part
115: Physical interfaces (FC-PI)
(8) ITU-T G.651.1
Characteristics of a 50/125 μm multimode graded
index optical fibre cable for the optical access network
(9) ITU-T G.652
Characteristics of a single-mode optical fibre and cable
(10) ITU-T G.707
Network node interface for the synchronous digital
hierarchy (SDH)
(11) ITU-T G.709
Interfaces for Optical Transport Network (OTN)
(12) ITU-T G.825
The control of jitter and wander within digital networks
which are based on the synchronous digital hierarchy (SDH)
(13) ITU-T G.957
Optical interfaces for equipments and systems relating
to the synchronous digital hierarchy
(14) ITU-T O.150
General requirements for instrumentation for
performance measurements on digital transmission equipment
(15) ITU-T O.151
Error performance measuring equipment operating at
the primary rate and above
(16) ITU-T O.172
Jitter and wander measuring equipment for digital
systems which are based on the synchronous digital hierarchy (SDH)
(17) ITU-T O.173
Jitter measuring equipment for digital systems which
are based on the Optical Transport Network (OTN)
(18) ANSI INCITS Project 2221-D / Rev 3.10
Fibre Channel - Physical
Interface-6 (FC-PI-6)
(19)
InfiniBand Architecture Specification Volume 2 Release 1.3.1
(20) CFP MSA
CFP Hardware Specification Revision 1.0
To Next Page
Loading...
