Chapter 2 Before Use
2-14
2.3.2 Connecting Power Cord
Insert the power plug into an outlet, and connect the other end to the
power inlet on the rear panel. To ensure that the MP2110A is properly
grounded, always use the supplied 3-pin power cord.
WARNING
Always connect the MP2110A to a properly grounded
outlet. Do not use the instrument with an extension cord or
transformer that does not have a ground wire.
If the MP2110A is connected to an ungrounded outlet, there
is a risk of receiving a fatal electric shock. In addition, the
peripheral devices connected to the MP2110A may be
damaged.
Unless otherwise specified, the signal-connector ground
terminal, like an external conductor of the coaxial
connector, of the MP2110A is properly grounded when
connecting the power cord to a grounded outlet. Connect
the ground terminal of DUT to a ground having the same
potential before connecting with the MP2110A. Failure to
do so may result in an electric shock, fire, failure, or
malfunction.
CAUTION
If an emergency arises causing the MP2110A to fail or
malfunction, disconnect the MP2110A from the power
supply by disconnecting either end of the power cord.
To Next Page
Loading...
