8.9 Storage
8-29
8
Maintenance
8.9 Storage
Wipe off dust, fingerprint marks, stains, spots, etc. from the surface of the
MP2110A before storing it.
Fit the attached coaxial connector cover to the coaxial connector on the
front panel. Also, put the cap on the optical connector.
Put the power cord, DVD-ROM and other accessories in the accessory box
and store it with the main frame.
For an Optical Scope, FC adaptor cap should be in place when the
MP2110A is not in use to prevent foreign material from entering the
optical connector.
Avoid storing the MP2110A in these places:
In direct sunlight for extended periods
Outdoors
In excessively dusty locations
In liquids, such as water, oil, organic solvents, and medical fluids, or
places where these liquids may adhere
In salty air or where chemically active gases (sulfur dioxide, hydrogen
sulfide, chlorine, ammonia, nitrogen oxide, or hydrogen chloride etc.)
are present
Where toppling over may occur
In the presence of lubricating oil mists
In places at an altitude of more than 2,000 m
In the presence of frequent vibration and mechanical shock, such as in
cars, ships, and airplanes
Places with temperatures and relative humidity in the following
ranges:
Temperature: lower than –20°C or higher than 60°C
Humidity: 90% or more
Recommended storage conditions
It is recommended that the MP2110A be stored in a place that meets the
ambient conditions suggested above, plus the following conditions, if it is
not to be used for a long period of time:
Temperature: 5 to 45°C
Humidity: 40 to 80%
Little temperature and humidity fluctuations within one day
To Next Page
Loading...
