5.2 PPG/ED Panel
5-9
5
How to Operate BERT
Setting Amplitude
1. Click the PPG Amplitude text box and set the amplitude voltage.
2. When the attenuators are inserted between the
Data Out
connector
and
Data
Out
connector of MP2110A and the DUTs, click the Ext
ATT text box and input the attenuation. The amplitude voltage after
passing through the attenuator is displayed.
CAUTION
When inserting attenuator at both the Data Out connector
and
Data
Out connector, use an attenuator with the same
amount of attenuation.
If the attenuation amounts are different, the displayed
amplitude and the amplitude output at the connector will
be different.
To Next Page
Loading...
