IDA8 Global-Net User Manual136
© 2020, ATEÏS. All rights reserved.
14.After calibration finished, DNM starts to work, It increases the level of audio if there is some noise
detected by DNM.
15.To save the parameter, click [Save parameter] in Ateis Studio.
3.2.3.2.2 DNM-485
1. Plug the DNM to the RS485(PDC) port of IDA8C/S (Here's the example using IDA8, the
configuration is the same for other Ateis Audio Processor).
2. Go to [Remote Search] on [Device Management] window.
3. After a popup window of [Remote Plugin-In] window appears, click the [Search] button to see the
DNM device the system has connected with. Then click [Plug-In] button to assign remote ID.
If the DNM device cannot be successfully searched by the system, please update the
firmware version which is newer than v1.0.0.5 at least.
To Next Page
Loading...
Need help?
General
