Fault List & Troubleshooting 481
© 2020, ATEÏS. All rights reserved.
7.2.6 DSP Boot Error
There is an internal error of communication between micro controllers inside devices.
Indication:
LED Indicator: When this error is detected, the following LEDs will light up:
o System Fault LED on the front panel of the IDA8C/S.
o G. Fault LED on the front panel of the IDA8C/S.
Log:
o "DSP Boot Error" messages display on the touch screen of the IDA8C.
o Text messages display at the [Machine Fault Record] window in Ateis Studio, see the
picture as below.
A buzzing sound will be outputted to the monitoring speaker on the front panel of the IDA8C.
7.2.7 Preset Table Error
The structure of configuration is not compatible with the current firmware.
Indication:
LED Indicator: When this error is detected, the following LEDs will light up:
o System Fault LED on the front panel of the IDA8C/S.
o G. Fault LED on the front panel of the IDA8C/S.
Log:
o "Preset Table Error" message displays on the touch screen of the IDA8C.
o A text message displays at the [Machine Fault Record] window in Ateis Studio, see the
picture as below.
A buzzing sound will be outputted to the monitoring speaker on the front panel of the IDA8C.
7.2.8 No Preset Table Error
There is no configuration inside the device.
Indication:
LED Indicator: When this error is detected, the following LEDs will light up:
o System Fault LED on the front panel of the IDA8C/S.
o G. Fault LED on the front panel of the IDA8C/S.
Log:
o "No Preset Table" message displays on the touch screen of the IDA8C.
o A text message displays at the [Machine Fault Record] window in Ateis Studio, see the
To Next Page
Loading...
Need help?
General
