DSP Components 407
© 2020, ATEÏS. All rights reserved.
6.15 Message
6.15.1 Message Player
This component plays the audio message files stored in your Ateis devices. It allows multiple events
binding with a message in the event list. Each event can be assigned for triggering source. If there is
more than one event triggered in the same message player component, the event with the highest
priority will play the message.
The smaller value has the higher priority.
Once you drag and drop the
component, you can set component
pins. See the picture on the right.
CR Pin: Cancel the event for triggering messages and clear all of the logic signals.
IR Pin: Interrupt. This will interrupt the messages and not play the messages.
Pause Pin (P): Trigger P pin is used to stop/continue the messages, it will restart exactly where
you paused.
Input Channel: The number of trigger channels.
Output Channel: The number of channels of message playing.
The [Message Player] component will occupied with 1 x message channels, please refer to
Message Limitation chapter.
Control Window
Event: Double click the message player to open the window shown as below.
To Next Page
Loading...
Need help?
General
