2. TRANSPORTATION AND PRECAUTIONS
When hoisting robot, the moving parts should be located properly to avoid unexpected movement which
can cause damage during hoisting and transportation. When packaging and transporting, it should follow
packaging standards and mark with the required signs outside the package.
When transporting, the robot must remain in its transport position stably.
The control box should be lifted using handle.
When moving robot from packaging to installation position, hold the robot in place until all mounting bolts
are safely tightened at the base of the robot.
Power up the robot after fixing it. Using hand-guiding to adjust robot orientation to a suitable location.
Save the original packaging after transportation. Store the packaging material in a dry place for future
repackaging and moving the robot.
Users can move the manipulator to the installation position by using the package project in the 【Online
Programming】->【Project】->【Open Project】on the AUBOPE Programming Environment. For
details, please refer to【Open Project】.(Image demonstration)
1. Make sure not to overload the robot’s back or other body parts when the equipment
is lifted.
2. All regional and national guidelines should be followed. AUBO (Beijing) Robotics
Technology Co., Ltd is not responsible for any damage caused during the
transportation of equipment.
3. Make sure to follow the instruction when installing a robot.
To Next Page
Loading...
