AUBO i5 - Getting Started; Safety; Notes before Use

THE I SERIES STANDARD CONTROL BOX V4.3
Page 76
©2015-2018 AUBO.All rights reserved.
 External I/O
Never insert or remove the USB device when the manipulator is running
Getting Started
Safety
As shown in figure 8.2, the red frames are danger zone with 100-240V AC and 48V DC. Never fix screws
or touch any mental components by hands directly and never remove living wires. Non-professionals do
not open the control box.
Non-professionals do not open the control box.
Figure 8.33 High voltage region inside I series control box.
Notes before use
 Check whether the control box power connectors are connected correctly.
 Check whether the control box and the robot are connected correctly.
 Check whether the control box and the teach pendant are connected correctly.
 Check whether the control box connectors are connected correctly.
 Check anchor bolts on control box support firmly and horizontally.