©2015-2018 AUBO.All rights reserved.
7. GETTING STARTED
Installation
Installing robots
Take out the AUBO robot from the packing box and install it on the base. Please read the specific installation
instructions in chapter 6: Installation.
1. Control box should be placed horizontally on the ground. A gap of 50mm on each
side is needed for sufficient air circulation
2. The teach pendant can be hung on the control box. Make sure that no one can step on
the cable.
1. Make sure that the control box, teach pendant, and cables are not in contact with
liquids. A wet control box can cause casualties.
2. The control box and the teach pendant should not be exposed to dusty or wet
environments that exceed IP20 rating. Pay close attention to the environment that
contains conductive dust.
To Next Page
Loading...
