Introduction Azbil Corporation
1-10 Model MGG10C/14C - MagneW FLEX+/PLUS+ Converter
Approval of this Device
Overview
If the basic model number is MGG14C and 1/2 NPT wiring connection is selected
and style code is selected as “N”, this device functions as an FM, non-incentive-
approved model. In this case, the installation standards described in this section must
be followed.
Installation of this device
FM Nonincendive model
THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I, DIVISION 2,
GROUPS(A, B, C, D), CLASS II/III, DIVISION 2, GROUPS (F, G), OR NON-
HAZARDOUS LOCATIONS ONLY.
CAUTION
• Power supply and internal voltage of ordinary equipment to the earth shall not
exceed AC250V 50/60HZ, DC250V in case of normal /formal conditions.
• Ambient temperature is from - 25 to 60C
• Process temperature is from -40 to 160C (Remote model).
• Process temperature is from -40 to 120C (Integral model)
To Next Page
Loading...