What to do if there is no pulse output from Azbil Media Converter?
If there is no pulse output from your Azbil Media Converter, check the wiring of the pulse output loop, the receiving device specifications (pulse width, frequency, voltage drop), and whether the pulse output is open collector type or Drive counter.
What to do if flow rate exceeds the flow range on Azbil Media Converter?
If the flow rate exceeds the flow range on your Azbil Media Converter, check the flow range setting to ensure it matches the detector and process flow. If it does not, set an appropriate RANGE. Also, verify that the flowmeter has been zeroed; if not, calibrate the flowmeter.
What to do if output remains 0mA on Azbil MagneW FLEX+/PLUS+ MGG10C Media Converter?
If the output remains 0mA on your Azbil Media Converter, verify the power source and power supply voltage, and check the wiring.
What to do if pulse output is too large or too small on Azbil MagneW FLEX+/PLUS+ MGG10C?
If the pulse output is too large or too small on your Azbil Media Converter, verify if the pulse weight and width are set correctly. Also, verify the converter is correctly calibrated, the pulse counter is proper, and the dropout value is correctly set between 0 and 10%.
What to do if communication cannot be done with Azbil MagneW FLEX+/PLUS+ MGG10C?
If communication cannot be done with your Azbil Media Converter, check the switch position (refer to Figure 2-15), ensure the wiring is properly completed, and check if the SFC is properly connected. Also, verify if the S/W version of the SFC is Ver.7.0 or later and if the HART communicator is 375, ensuring the DD file is downloaded.
What to do if Hysteresis exceeding 100% of range in normal/ reverse automatic range on Azbil MagneW FLEX+/PLUS+ MGG10C Media Converter?
If the Hysteresis exceeds 100% of range in normal/ reverse automatic range on your Azbil Media Converter, check hysteresis setting.
What to do if Azbil Media Converter displays ADC error A/D change error?
If your Azbil Media Converter displays an ADC error A/D change error, cycle power. If the issue persists, replace the main card.
What to do if Azbil Media Converter shows NVM read after write error?
If your Azbil Media Converter shows an NVM read after write error, cycle power. If the issue persists, replace main card.
What to do if Azbil Media Converter shows detector type and diameter mismatch?
If your Azbil Media Converter indicates that the detector type and diameter do not match, check the setting for the detector diameter and enter the correct diameter.
What to do if Azbil MagneW FLEX+/PLUS+ MGG10C Media Converter pulse width is too large?
If the pulse width is too large on your Azbil Media Converter, check the pulse width, pulse weight, and span setting.
General| Brand | Azbil |
|---|---|
| Model | MagneW FLEX+/PLUS+ MGG10C |
| Category | Media Converter |
| Language | English |
To Next Page
