Using the display panel Azbil Corporation
4-4 Model MGG10C/14C - MagneW FLEX+/PLUS+ Converter
MEASURING MODE
This is the normal operational mode. In this mode, the screen indicates the measuring
status. What is displayed on screen depends upon the setting selections made in the
other modes.
This mode performs one other important function. Entering this mode causes the
system to save settings entered in other modes. Each time the MEASURING MODE
is selected, data is written into memory. Settings entered in other modes are held in
temporary memory for two minutes, but will return to the previously saved value
unless the MEASURING MODE is selected. The only exception is the counter,
which is always saved into memory immediately.
CAUTION
After entering settings in other modes, ALWAYS immediately select the
MEASURING MODE to save settings.
To Next Page
Loading...