Azbil MagneW FLEX+/PLUS+ MGG10C - Page 61

Azbil Corporation Using the display panel
Model MGG10C/14C - MagneW FLEX+/PLUS+ Converter 4-7
Single range
(*8) : Indicated when normal direction dual range or normal/reverse
direction range is selected.
(*9) : Indicated when high/low limit alarms are set for the contact output in
function setting.
(*10): May indicate "DUTY50%" instead of "NUM".
(*11): Indicated when 1-contact output/1-contact input is reqistered in function setting.
(*12): Indicated when 2-contact output is used.
(*13): Indicated when single range H1-L1/H2-L2 is selected in function setting.
# FUNC SET FOAXX
# PLS 27.778 Hz
SCL 100.00 cm3/P
(*8)(*10)
(*10)
(*9)
# HI-ALM +100 %
LO-ALM -100 %
# HI-ALM1 +100 %
LO-ALM2 +100 %
# FAIL SAFE MODE
I.OUT HOLD
# FAIL SAFE MODE
P.OUT HOLD
(*13)
D
# HI-ALM1 -100 %
LO-ALM2 -100 %
(*13)
# ST. OUT MODE
NORMAL CLOSE
(*11)
# ST. OUT1 MODE
NORMAL CLOSE
(*12)
# ST. OUT2 MODE
NORMAL CLOSE
(*12)
Dual range
(*10)
(*8)(*10)
# MODE RETURN
BASIC SETUP
# PLS 27.778 Hz
SCL 100.00 cm3/P
# PLS 27.778 %
WID NUM 010.00ms
# PLS1 27.778 %
WID NUM 010.00ms
(to be continued)