What to do if output exceeds 100% on Azbil MagneW FLEX+/PLUS+ MGG10C?
If the output exceeds 100% on your Azbil Media Converter, verify that the set range, span and zero point are correctly adjusted. Also, ensure that the converter is correctly calibrated.
What to do if flow rate exceeds the flow range on Azbil Media Converter?
If the flow rate exceeds the flow range on your Azbil Media Converter, check the flow range setting to ensure it matches the detector and process flow. If it does not, set an appropriate RANGE. Also, verify that the flowmeter has been zeroed; if not, calibrate the flowmeter.
What to do if output remains 0mA on Azbil MagneW FLEX+/PLUS+ MGG10C Media Converter?
If the output remains 0mA on your Azbil Media Converter, verify the power source and power supply voltage, and check the wiring.
What to do if pulse output is too large or too small on Azbil MagneW FLEX+/PLUS+ MGG10C?
If the pulse output is too large or too small on your Azbil Media Converter, verify if the pulse weight and width are set correctly. Also, verify the converter is correctly calibrated, the pulse counter is proper, and the dropout value is correctly set between 0 and 10%.
General| Brand | Azbil |
|---|---|
| Model | MagneW FLEX+/PLUS+ MGG10C |
| Category | Media Converter |
| Language | English |
To Next Page
