EasyManua.ls Logo

Barco DP2K-36BLP - Page 116

Barco DP2K-36BLP
185 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9. ICMP
How to install a HDD ?
1. E nsur e that the projector is s witched off.
2. P repare the HDD for insertion by mov ing the latch towards the left and push the unlock bu tton to open the handle.
Image 9-15
3. Insert the HDD into the HDD slot. Ensure that the handle is sufciently open so that the hook (reference 1) of the handle c an
pass the front plate of the ICMP.
1
Image 9-16
4. P ush the HDD completely and rm ly inside its slot, close the handle, and move the latch towards the right.
Image 9-17
5. S w itch on the projector.
In case y ou replace one HDD (
e.g. degraded mo de) the ICMP autom atically starts with the R A ID recovery
process. The red LED of the HDD which ha s t o b e rebuilt is blinking. This process takes about 200 GB per
hour. Once the RAID is completed the red LED turns off.
CAUTION: It’s strongly recom m ended to complete the RAID recovery process prior to starting a show. This
to ensu re that the content integrity is preserved and that the show is n ot interrupted.
112 R5906753 DPXK BLP SERIES 20/11/2017

Table of Contents

Related product manuals