Cadex C8000 - Page 289

C8000 Battery Testing System User Manual
5 Status Messages 277
210
BAD WAVEFORM
THE REQUESTED WAVEFORM EXCEEDS EITHER THE
SYSTEM MAXIMUM LIMITS OR IS GREATER THAN THE
BATTERY LIMIT AS DEFINED IN THE C-CODE
211
WATTS > MAX
THE REQUESTED POWER (WATTAGE) IS GREATER THAN
THE SYSTEM MAXIMUM OF 100W (CHARGE) / 80W
(DISCHARGE)
212
WAVEFORM FAULT
ONLY ONE SUB-MILLISECOND WAVEFORM ALLOWED PER
CHANNEL PAIR
215
LOW_OFFSET_ERROR
THE AUTOMATED CALIBRATION FOR THE LOAD CAPTURE
UNIT IS OUT OF RANGE
218
LCU_CHANNEL_1_ONLY
LOAD CAPTURE DEVICE IS SUPPORTED ON CHANNEL 1
ONLY
219
LCU_CAPTURING
LOAD CAPTURE UNIT IS CAPTURING DATA
220
LOOP CNT TEST
LOOP COUNTER TEST
221
VOLTAGE TEST
VOLTAGE TEST
222
CURRENT TEST
CURRENT TEST
223
TEMP. TEST
TEMPERATURE TEST
224
DELTA-T TEST
DELTA-TEMPERATURE TEST TEMPERATURE TEST
225
IMPED. TEST
IMPEDANCE/RESISTANCE TEST
226
ERROR CODE TEST
ERROR CODE TEST
227
VARIABLE TEST
VARIABLE TEST
228
VARIABLE DIFF
VARIABLE DIFFERENCE TEST
229
AUX. PORT TEST
AUX. PORT TEST
230
AUX. DIFF TEST
AUX. DIFFERENCE TEST
231
LCU_REVERSED
LOAD CAPTURE DEVICE IS DETECTING A REVERSE
CURRENT FLOW
232
LCU_CALIBRATING
LOAD CAPTURE UNIT IS BEING CALIBRATED
233
TEMPERATURE OF
RANGE
TEMPERATURE IS OUT-OF-MEASURABLE RANGE
234
PARALLEL
CHANNEL IS IN PARALLEL MODE
236
NO PRIMARY CHG
NO CHARGE ALLOWED ON PRIMARY CELLS
255
OFFLINE
DSP CONTROLLER IS “OFFLINE”