Calrec Apollo - Changes to Screen Locations in the Main Application from V6.0

Introduction
14 APOLLO
Digital Broadcast Production Console
CHANGES TO SCREEN LOCATIONS IN THE MAIN APPLICATION FROM V6.0
For a long time, the Apollo and Artemis
main application has grouped functions
under the top-level menu items
“Other Options” and “Fixed Options”.
These titles have been changed to
“Show Settings” and “System Settings”
respectively. In the screens contained
under each of these top-level menus
some screens have been moved and in
some cases renamed to make them easier
to find, and to make it clearer where the
data is stored and how it changes.
The “Show Settings” area contains only
settings that are stored and recalled at
show level.
The System Settings” area contains the
remaining functions that are stored at
system level, and do not change with
shows.
The table in Fig 1 shows the Old and
New names and locations of the various
screens for reference purposes before
and after the V6.0 release.
Misc/Default Settings General Settings
Inserts Setup moved to System Settings
Meter Setup Meter Layout
Mon/Mtr Ext I/P moved to System Settings
User Split User Split
Down Mix Down Mix
Ext Control Ext Control
External Inputs (from Other Options)
(was Mon/Mtr Ext I/P)
Mon TB MTR Patch Fixed I/O
Inserts Setup (from Other Options)
LAN Config (for 2015 cores only)
Surface Illum Surface Illum
Surface Layout Surface Layout
Sync Sync
TX/REH TX/REH
FIG 1 - SCREEN LOCATION AND NAME CHANGES IN V6.0 ONWARDS
Pre V6.0 Post V6.0