Control Panel Modes
50 APOLLO
Digital Broadcast Production Console
STRIPS MODE
Strips mode arranges the wild assign
panel controls and touchscreen into
vertical strips with the same controls
above each fader on a panel by panel
basis. This provides quick access to
up to six strip controls and a section
of the TFT touchscreen for each fader.
A wild assign panel set into Strips mode
is shown in Fig 1. Currently there are a
range of pre-configured strips available
for use.
Accessing Strips mode
To set a wild assign panel into Strips
mode, touch the STRIPS button on the
Modes row at the top of the fader panel.
If the Strips bu tton is not visible on the
Modes row, make sure that the panel is
not locked by checking the status of the
MODE LOCK button also located on the
Modes row. The MODE LOCK button is
always available even in strip type select
mode, allowing the user to switch between
STRIPS mode and strip type select mode
while locked to STRIPS.
Selecting STRIPS mode will display the
last used strip type on the panel and show
the available strip type buttons.
Apply to All Strips
By default, the user-wide Apply To All
Strips button is ON, and pressing the strip
type applies it to all panels in that console
area. Turn Apply To All Strips off to allow
individual panels to change to different
strip types.
Routing display
Each strip on the TFT contains a routing
overview for the relevant fader. Tapping
on the TFT overview expands that strip
to allow access to all the bus outputs of
that type to add or remove routes to that
output from that channel.
FIG 1 - STRIPS MODE LAYOUT
To Next Page
Loading...
