Calrec Apollo - TALKBACK

Communications
154 APOLLO
Digital Broadcast Production Console
TALKBACK
Talkback facilities can be set up and
activated through the monitor panel,
shown in Fig 1.
The left hand side of the TFT panel, when
in monitor mode can switch between
viewing talkback selection and user
memories from the button cell in the
bottom left corner of the mode area, as
shown in Fig 1.
Live talkback routing
To toggle talkback, touch a destination
in the left hand side of the touchscreen,
below the words ‘Live Talkback’.
The talkback latches, allowing
multiple destinations to be selected
simultaneously.
Talkback groups
There are four talkback groups
available which can be set up to allow
multiple talkback destinations to be fed
simultaneously with a single button press.
These group controls are located in the
middle row of control cells at the left hand
side of the panel.
To set a talkback group’s destinations,
touch and hold the upper SEL button
in the relevant control cell, then tap the
required destinations on the touchscreen.
To toggle talkback to a group, press the
lower TALK button in the relevant control
cell.
Talkback & Reverse Talkback levels
The level of the talkback may be adjusted
using the TB control.
There are three reverse talkback inputs
into the system. The level of these feeds
may be adjusted using the RTB 1, 2 or 3
controls.
The Talkback level controls are located in
the two top left control cells in Talkback/
Monitor page of the Wild Assign panel.
FIG 1 - TALKBACK CONTROLS IN MONITOR MODE