CALREC Putting Sound in the Picture 213
V8.0
• Support for RP1- RP1 provides a
powerful solution for remote, or at-
home, productions. RP1 gives you
the power to manage I/O and create
zero-latency monitor mixes at venues
all over the world, all from the comfort
and familiarity of the Calrec console
at the host production facility. The
Apollo and Artemis Consoles can host
multiple RP1 units allowing remote
production control. RP1 also features
a convenient HTML interface called
Calrec Assist, accessible from any PC
with a browser. You can use this to set
up, configure, control, or diagnose RP1
even when you’re not next to a console.
• 96 kHz Operation
Apollo & Artemis consoles can now
work at 96 kHz, switching between
48 kHz & 96 kHz working as required.
Consoles switch sampling frequency by
loading a show at the required sample
rate. The amount of channel and bus
resources is reduced when working
at 96 kHz but the numbers at 48 kHz
remain the same as always. There
is no reduction in monitor inputs and
outputs at 96 kHz, or any reduction in
path processing capabilities.
• I/O boxes can be set to work at
48 kHz or 96 kHz, or to follow the
sample rate of a specific console as it
changes rates. The Hydra2 network
supports 48 kHz & 96 kHz consoles
and I/O boxes simultaneously.
• Support for third party Hydra2
Products- support for third party
products with Hydra2 interfaces, such
as the Evertz 7800EMR-HYDRA2
TDM to Hydra2 Bidirectional Interface
Module and the TSL MPA1-Mix/Solo-
HYDRA2.
• Protection against accidental removal
of multiple connected destinations in
the patching screen.
• Pressing the access button to route a
path in contribution mode will no longer
cause the accessed path to change.
Paths can be accessed in contribution
mode by holding an access button for
half a second.
• Sidechain’ Independence renamed to
‘Gain Reduction’ independence.
• Improved visibility of intermittent cable
failures.
• Access buttons respond correctly on
changing layers using All A or All B.
V8.1
• Support for AD6365 Transformer
Isolated Mic/Line modular I/O card.
To Next Page
Loading...
