Control Overview
24 APOLLO
Digital Broadcast Production Console
There are two, eight wide control cell rows
that span the width of the panel which are
highlighted in Fig 3.
The Modes row is used to control the
mode of the wild assign panel above it.
The Layers row is used for layer switching
and accessing certain other panel
functions.
The Functions row changes between
displaying controls relevant to each fader
(as shown in the previous figure), or a
range of setup and configuration options
which do not directly relate to any one
fader.
It is an important to make the distinction
that unlike other displays and controls on
the panel, these rows are not linked to a
single fader.
FIG 3 - FADER PANEL ROWS
To Next Page
Loading...
