Canon LBP352 - Configuring Ethernet Settings

Conguring Ethernet Settings
0X7U-038
Ethernet is a standard for communicating data in a local area network (LAN). You can set
the communication mode (half-duplex/full-duplex) and the Ethernet type (10BASE-T/
100BASE-TX/1000BASE-T). In general, the machine can be used without changing the
defaults ( Ethernet Driver(P. 391) ), but you can change these settings to suit your
network environment.
1
Press ( ).
2
Use / to select <Network>, and press .
● When a message appears, press .
3
Select <Ethernet Driver> <Auto Detect>.
4
Select whether to congure Ethernet settings automatically or manually.
Conguring Ethernet settings automatically
Select <On> and press . The machine detects and automatically sets the communication mode and the
Ethernet type that can be used.
Conguring Ethernet settings manually
1
Select <Off>, and press .
2
Select the communication mode.
● Select <Communication Mode> Select <Half Duplex> or <Full Duplex>
<Half Duplex>
Alternately sends and receives communication data. Select when the machine is connected to a
networking device using half duplex.
<Full Duplex>
Simultaneously sends and receives communication data. Use this setting for most environments.
Network
217