Loading Envelopes
0X7U-010
Make sure to atten any curls on envelopes before loading them. Also pay attention to the orientation of envelopes
and which side is face up. Note that envelopes cannot be loaded in the paper drawer.
Before Loading Envelopes(P. 53)
Loading Envelopes in the Multi-Purpose Tray(P. 54)
● This section describes how to load envelopes in the orientation you want, as well as procedures that you
need to complete before loading envelopes. For the general procedure for loading envelopes in the multi-
purpose tray or optional envelope feeder, see the following.
Loading Paper in the Multi-Purpose Tray(P. 44)
Loading Envelopes in the Envelope Feeder (Option)(P. 50)
Before Loading Envelopes
Follow the procedure below to prepare the envelopes before loading.
● Envelopes cannot be ejected into the output tray. Make sure to open the sub-output tray.
1
Close the ap of each envelope.
2
Flatten them to release any remaining air, and make sure that the edges are pressed
tightly.
Basic Operations
53
To Next Page
Loading...
Need help?
General
