Canon LBP352 - Setting a Remote UI PIN

Setting a Remote UI PIN
0X7U-03Y
You can set a PIN for access to the Remote UI. All users use a common PIN.
● When Department ID Management is enabled, setting here is not required.
Setting the Department ID
Management(P. 256)
1
Press ( ).
2
Use / to select <Network>, and press .
● When a message appears, press .
3
Select <Remote UI Settings> <RUI Access Sec. Set.>.
4
Select <On>, and press .
5
Select <Remote UI Access PIN>, and press .
6
Set a PIN.
● Enter up to 7 digits and press .
● As <Conrm PIN> is displayed for conrmation, enter again the same PIN digits.
If Remote UI settings are initialized
● The Remote UI Access PIN is also initialized. After an initialization, reset the PIN. Initializing Menu(P. 551)
LINKS
Setting Access Privileges(P. 252)
Setting the System Manager Password(P. 253)
Security
263