4-40 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setup Menu: IP, Continued
SNMP Read Community String
Description: The SNMP Community Read field is used when communicating
with a device within an SNMP environment. These commands
allow you to set the password to read and write data to a device to
display diagnostics traps/alarms. The options are public (default)
and or a custom string.
Parameters: Use the default community string called public or enter a custom
community string. To set a custom community string, enter an
alphanumeric character string up to 31-characters in length
identifying the password for the device. Note that the community
string is case-sensitive.
SNMP Write Community String
Description The SNMP Community Write field is used when communicating
with a device within an SNMP environment. These commands
allow you to set the password to read and write data to a device to
display diagnostics traps/alarms. The options are public (default)
and or a custom string.
Parameters: Use the default community string called public or a custom
community string. To set a custom community string, enter an
alphanumeric character string up to 31-characters in length
identifying the password for the device. Note that the community
string is case-sensitive.
Reset Telnet Logins
Description: Resets the username and password for Telnet and HTTP logins to
its default values.
Note: To change your password, refer to Setting Admin User
Privileges via a Telnet Connection, page 3-16. If you need to
change your username, you must be an Admin user.
TRAP DESTINATIONS
Trap IP Address
Description: This sets the destination for SNMP trap messages for events (i.e.,
fault messages).
Parameters: Up to 12 digits in length, e.g., 155.128.100.200.
To Next Page
Loading...
