4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 4-43
Setup Menu: Services, Continued
VIDEO
PV Format
Description: Indicates the output video format. This value is read-only.
Parameters: Auto, SD, HD 720p, or HD 1080i.
Stream
Description: This is the format of the incoming stream. It is determined by the
the SD Format setting and the actual format of the incoming stream.
This value is read-only.
SD Format
Description: Selects the video format for the output when the input video is SD
format.
Parameters: Auto, NTSC, PAL-N (AR), PAL-M or PAL-B/G/I/D. Use NTSC for
525-line systems and PAL-B/G/I/D for 625-line systems.
SD Output
Description: Indicates the SD Output video signal format.
Parameters: NTSC, PAL-N (AR), PAL-M or PAL-B/G/I/D.
Bitrate
Description: Indicates the video output bit rate.
Parameters: 1.0 to 15.0 Mbps.
Tri-Synch
Description: Indicates whether component Tri-Synch is enabled or disabled.
Parameters: Enabled or Disabled.
Alarm Video Cutoff
Description: Sets whether the video output is cut off if any enabled alarm is
active on the receiver. When video is cut off, there will be no
horizontal or vertical synchronization on the output. This is useful
for downstream redundancy switching by detecting a loss of video
signal.
Note: This same function also exists under Setup: Alarm/Warning.
Parameters: Enable or Disable. The default is Disable.
To Next Page
Loading...
