4-72 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setup Menu: Outputs, Continued
TS/IP
Description: This selects the maximum number of transport packets per IP
packet.
Parameters: 1 to 7.
Min IP/s
Description: This selects the minimum number of transport packets per IP
packet.
Parameters: 0, 2 to 1000.
PCR@IP Start
Description: This selects whether to always transmit a new Ethernet Packet
when a new Program Clock Reference (PCR) arrives.
Parameters: Yes or No.
MGMT Port Mode, DATA Port Mode
Description: This selects the Management and Data MPEGoIP modes.
Note: If No Output was selected for MOIP1 Output Mode, updates
to the port modes will have no affect.
Parameters: No Output, IGMP or Always Output.
SAP Multicast Address
Description: This is the SAP destination IP address.
Parameters: 0 to 255 for each of the four fields in the format ###.###.###.###.
PCR Addition
Description: This selects whether to add a PCR to the output stream.
Parameters: Yes or No.
MGMT Mode
DATA Mode
Description
No Output Disables the MPEGoIP interface.
Always Output Always outputs data on the port.
Note: You cannot select Always Output for
both ports simultaneously.
To Next Page
Loading...
