Cisco D9854 - Page 133

4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 4-71
Setup Menu: Outputs, Continued
Insert Null Packet
Description: This parameter selects whether to insert null packets in the output
stream.
Parameters: Yes or No.
Instance Name
Description: This is the DPM output instance name.
Parameters: Up to 31 characters.
MOIP
Description: Selects the transport protocol to be used for the output stream.
Parameters: RTP or UDP.
Send SAP
Description: This selects whether to send Session Announcement Protocol
messages.
Parameters: Yes or No.
SAP ID
Description: This is the SAP identifier (ID)/string.
Parameters: Up to 49 characters.
DestAddr
Description: Enter the multicast destination IP address.
Parameters: 0 to 255 for each of the four fields in the format ###.###.###.###.
For example, 225.1.1.1.
UDPPort
Description: This selects the destination port number.
Parameters: 1 to 65535.
Note: If you selected RTP for MOIP, you must select an even
destination port number.
SrcPort
Description: This selects the source UDP port number.
Parameters: 0 to 65535.