4-78 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setup Menu: Outputs: TS Out: DPM, Continued
PSI Rate
Description: This selects the DPM regeneration rate. This applies the PowerVu
rates (consistent with the uplink). This parameter is only used if
Remapping Control is set None.
Parameters: Auto, MPEG Min or SA Std.
Service ID
Description: This parameter specifies whether the receiver should always
generate PSI tables for the Mapped PE even if the selected input
channel is not available, or for only valid service channels/IDs.
Parameters: Valid Ch, All Ch.
PSI Rate Description
Auto Matches the generated PSI tables' output
rate as the incoming rate.
MPEG Min Transmits the generated PSI tables on the
longest intervals that are allowed by MPEG
standard.
SA Std Transmits the generated PSI tables based on
PowerVu standard intervals.
Svc ID Description
Valid Ch Only transmits the PSI tables for the
mapped program if the program exists on
the input stream.
All Ch Transmits the PSI tables for the mapped
program even if the program does not exist
in the input stream.
All Ch is only valid if the PAT, NIT, SDT
and PMT are set to Regenerate.
To Next Page
Loading...
