4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 5-37
Configuring the Transport Stream: DPM Global, Continued
5. In the Remapping Mode drop-down, select the DPM map mode. The following
table describes each mode:
6. Select the Duplication Method of the DPM program, which modifies the PSI to
duplicate a program and its content. This parameter is only used if Remapping
Mode is set to Svc ID & PID. The following table describes the each duplication
method:
Pkt Copy is recommended for most applications.
7. Select the DP action to use for Unreferenced Content. Unreferenced content is
the remainder of the transport that is not filtered by the program entries. You
can select Drop All (default) or Pass All.
Map Mode Description
Svc ID The elementary PIDs are not changed. Channels are
remapped by changing their PSI references. When this
mode is selected, PE detailed PID mapping cannot be
edited.
Svc ID & PID Channels and the elementary service PIDs can be
mapped.
Duplic Mode Description
PSI Remap Every input PID can be mapped to one output PID. If
PID mapping conflicts exist, DPM will use the
Precedence Rule to decide which output PID to use. All
PMTs using the input PID will be updated to reference
the output PID specified by the winner.
Pkt Copy An input PID can be mapped to multiple output PIDs.
The PID will be duplicated as many times as needed (up
to a certain hardware limitation).
Output Unref
ASI Pass, Drop
MOIP1 Pass, Drop
To Next Page
Loading...
Need help?
General
