Cisco D9854 - Page 207

4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 5-43
13. Click Save.
14. Select the DPM Table Opt radio button and set the following parameters:
Unreferenced Content Drop
PSI Table Output Option Ctl By Table
Regeneration Rate Option Any
Service ID Output Any
Parameter Description
PAT Regen
CAT Regen
PMT Regen
TSDT Drop
NIT Regen or Drop
NITO Drop
SDT Regen
SDTO Drop
BAT Drop
EIT Drop
TDT Pass
RST Pass
TOT Pass
DIT Pass
SIT Pass
ECM Drop
EMM Drop
DRT Drop
Parameter Description