Cisco D9854 User Manual

4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 6-9
WDOG task:
watchdog Secondary
WD has expired
WDOG task:
watchdog MCM[S]
has expired
SMI Setup Set Phase lock error on
SMI SDRAM
Cause: Hardware
Issue.
Remedy: Clear
alarms, reset the unit,
and notify customer
service if the problem
persists.
SDRAM on SMI
bus not working.
Major
SMI SDRAM exhaust
test failed
Clear SMI SDRAM setup
successful
SDRAM on SMI
Bus OK.
SMI SDRAM exhaust
test passed
LMI setup Set LMI SDRAM exhaust
test failed
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the unit,
and notify customer
service if the problem
persists.
DDR RAM on
LMI bus not
working.
Major
Clear LMI Video SDRAM
exhaust test passed
DDR RAM on
LMI bus OK.
Param Storage Set DB NVS flushing
ignored
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the unit,
and notify customer
service if the problem
persists.
Non-volatile
storage system
failed to update
fully.
Major
RAM flush to NVS
failed
DB Factory Reset
failed
Non-volatile
storage system
failed during
factory reset.
Clear DB flushing
completed
Successful NVS
update.
DB Factory Reset
completed
Successful
action.
Alarm Message
Type
Message Cause/Remedy Description Severity

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C