4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 4-29
Setup Menu: Admin, Continued
DL Status, Type, Bank
Description: Indicates the DL Mode status, type and bank (i.e., type of code).
Parameters: DL Status - Idle, Running, Timeout. Idle indicates the receiver is
waiting for a download. Running indicates the receiver is
processing a download. Timeout indicates the receiver didn’t
complete the download.
Type - rear panel is only supported at present.
Bank - the type of code, either Application or FPGA.
CDT#
Description: Indicates the total number of expected CDTs, the number received,
the number rejected and the download command.
Parameters: This is the number of tables expected to be received during the
current download operation.
Recv
Description: This is the number of CDTs received since the last completed or
aborted download, or power-cycle.
Parameters: Read-only numeric value.
Reject
Description: This is the rejected table count. Tables are rejected whenever
validation fails due to things like CRC failure or incorrect code or
receiver type.
Parameters: Read-only numeric value.
Command
Description: Indicates the download command.
Parameters: Restart, Abort or None. Abort stops a download that is currently
being received. Restart restarts a previously aborted download.
Note that the download does not resume from where it was
aborted, but restarts from the beginning. None means no action is to
be performed.
To Next Page
Loading...
