Cisco IE-3000-8TC Command Reference

2-77
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
dot1x
This example shows how to globally enable the optional guest VLAN behavior on a switch:
Switch(config)# dot1x guest-vlan supplicant
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands Command Description
dot1x critical (global
configuration)
Configures the parameters for the inaccessible authentication bypass
feature on the switch.
dot1x guest-vlan Enables and specifies an active VLAN as an IEEE 802.1x guest VLAN.
dot1x port-control Enables manual control of the authorization state of the port.
show dot1x [interface
interface-id]
Displays IEEE 802.1x status for the specified port.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes