Cisco IE-3000-8TC Command Reference

B-42
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug platform port-asic
debug platform port-asic
Use the debug platform port-asic privileged EXEC command to enable debugging of the port
application-specific integrated circuit (ASIC) driver. Use the no form of this command to disable
debugging.
debug platform port-asic {interrupt | periodic | read | write}
no debug platform port-asic {interrupt | periodic | read | write}
Syntax Description
Note Though visible in the command-line help strings, the stack keyword is not supported.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform port-asic command is the same as the no debug platform port-asic command.
Related Commands
interrupt Display port-ASIC interrupt-related function debug messages.
periodic Display port-ASIC periodic-function-call debug messages.
read Display port-ASIC read debug messages.
write Display port-ASIC write debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes