Cisco IE-3000-8TC Command Reference

B-12
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug interface
debug interface
Use the debug interface privileged EXEC command to enable debugging of interface-related activities.
Use the no form of this command to disable debugging.
debug interface {interface-id | null interface-number | port-channel port-channel-number |
vlan
vlan-id}
no debug interface {interface-id | null interface-number | port-channel port-channel-number |
vlan
vlan-id}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you do not specify a keyword, all debug messages appear.
The undebug interface command is the same as the no debug interface command.
Related Commands
interface-id Display debug messages for the specified physical port, identified by switch
or module number/port, for example gigabitethernet 1/2.
null interface-number Display debug messages for null interfaces.
port-channel
port-channel-number
Display debug messages for the specified EtherChannel port-channel
interface. The port-channel-number range is 1 to 6.
vlan vlan-id Display debug messages for the specified VLAN. The vlan-id range is 1 to
4094.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show etherchannel Displays EtherChannel information for the channel.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes