Cisco IE-3000-8TC Command Reference

B-16
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug ip igmp snooping
debug ip igmp snooping
Use the debug igmp snooping privileged EXEC command to enable debugging of Internet Group
Management Protocol (IGMP) snooping activity. Use the no form of this command to disable debugging.
debug ip igmp snooping [group | management | querier | router | timer]
no debug ip igmp snooping [group | management | querier | router | timer]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug ip igmp snooping command is the same as the no debug ip igmp snooping command.
Related Commands
group (Optional) Display IGMP snooping group activity debug messages.
management (Optional) Display IGMP snooping management activity debug messages.
querier (Optional) Display IGMP snooping querier debug messages.
router (Optional) Display IGMP snooping router activity debug messages.
timer (Optional) Display IGMP snooping timer event debug messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
debug platform ip
igmp snooping
Displays information about platform-dependent IGMP snooping activity.
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes