Cisco IE-3000-8TC Command Reference

B-52
Cisco IE 3000 Switch Command Reference
OL-13019-01
Appendix B IE 3000 Switch Debug Commands
debug platform udld
debug platform udld
Use the debug platform udld privileged EXEC command to enable debugging of the
platform-dependent UniDirectional Link Detection (UDLD) software. Use the no form of this command
to disable debugging.
debug platform udld [all | error | rpc {events | messages}]
no debug platform udld [all | error | rpc {events | messages}]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform udld command is the same as the no debug platform udld command.
Related Commands
all (Optional) Display all UDLD debug messages.
error (Optional) Display error condition debug messages.
rpc {events | messages} (Optional) Display UDLD remote procedure call (RPC) debug messages.
The keywords have these meanings:
• events—Display UDLD RPC events.
• messages—Display UDLD RPC messages.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes