Cisco IE-3000-8TC Command Reference

2-443
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
show monitor
show monitor
Use the show monitor user EXEC command to display information about all Switched Port Analyzer
(SPAN) and Remote SPAN (RSPAN) sessions on the switch. Use the command with keywords to show
a specific session, all sessions, all local sessions, or all remote sessions.
show monitor [session {session_number | all | local | range list | remote} [detail]] [ | {begin |
exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
The output is the same for the show monitor command and the show monitor session all command.
Examples This is an example of output for the show monitor user EXEC command:
Switch# show monitor
Session 1
---------
Type : Local Session
Source Ports :
RX Only : Fa1/1
Both : Fa2/2-3,Fa2/5-6
session (Optional) Display information about specified SPAN sessions.
session_number Specify the number of the SPAN or RSPAN session. The range is 1 to 66.
all Display all SPAN sessions.
local Display only local SPAN sessions.
range list Display a range of SPAN sessions, where list is the range of valid sessions,
either a single session or a range of sessions described by two numbers, the
lower one first, separated by a hyphen. Do not enter any spaces between
comma-separated parameters or in hyphen-specified ranges.
Note This keyword is available only in privileged EXEC mode.
remote Display only remote SPAN sessions.
detail (Optional) Display detailed information about the specified sessions.
| begin Display begins with the line that matches the expression.
| exclude Display excludes lines that match the expression.
| include Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(44)EX This command was introduced.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes