Cisco IE-3000-8TC Command Reference

2-10
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
alarm profile (global configuration)
alarm profile (global configuration)
Use the alarm profile global configuration command to create an alarm profile and to enter alarm profile
configuration mode. Use the no form of this command to delete an alarm profile.
alarm profile name
no alarm profile name
Syntax Description
Defaults No alarm profiles are created. However, there is a default profile for all interfaces called defaultPort.
When a profile is created, none of the alarms are enabled.
Command Modes Global configuration
Command History
Usage Guidelines In alarm-profile configuration mode, these commands are available:
• alarm alarm-id: enables the specified alarm.
• exit: exits from alarm-profile configuration mode.
• help: displays a description of the interactive help system.
• no: negates or sets the default values of a command.
• notifies alarm-id: enables notification for the alarm, which means sending a Simple Network
Management Protocol (SNMP) trap to an SNMP server.
• relay-major alarm-id: enables sending the alarm to the major relay circuitry.
• relay-minor alarm-id: enables sending the alarm to the minor relay circuitry.
• syslog alarm-id: enables sending the alarm to a syslog file.
For alarm-id, you can enter one or more alarm IDs separated by a space.
Before you use the notifies keyword to send alarm traps to a SNMP host, you need to set up an SNMP
server by using the snmp-server enable traps global configuration command.
There is a default profile for all interfaces. Enter the show alarm profile user EXEC command and see
the output for defaultPort.
Table 2-1 lists the alarm IDs and the corresponding alarm descriptions.
name Alarm profile name
Release Modification
12.2(44)EX This command was introduced.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes