Cisco IE-3000-8TC Command Reference

2-278
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
queue-set
queue-set
Use the queue-set interface configuration command to map a port to a queue-set. Use the no form of this
command to return to the default setting.
queue-set qset-id
no queue-set qset-id
Syntax Description
Defaults The queue-set ID is 1.
Command Modes Interface configuration
Command History
Examples This example shows how to map a port to queue-set 2:
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# queue-set 2
You can verify your settings by entering the show mls qos interface [interface-id] buffers privileged
EXEC command.
Related Commands
qset-id ID of the queue-set. Each port belongs to a queue-set, which defines all the
characteristics of the four egress queues per port. The range is 1 to 2.
Release Modification
12.2(44)EX This command was introduced.
Command Description
mls qos queue-set output buffers Allocates buffers to a queue-set.
mls qos queue-set output threshold Configures the weighted tail-drop (WTD) thresholds,
guarantees the availability of buffers, and configures the
maximum memory allocation to a queue-set.
show mls qos interface buffers Displays quality of service (QoS) information.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes