Cisco IE-3000-8TC - Chapter 1 Using the Command-Line Interface; CLI Command Modes

CHAPTER
1-1
Cisco IE 3000 Switch Command Reference
OL-13019-01
1
Using the Command-Line Interface
The IE 3000 switch is supported by Cisco IOS software. This chapter describes how to use the switch
command-line interface (CLI) to configure software features.
• For a complete description of the commands that support these features, see Chapter 2, “IE 3000
Switch Cisco IOS Commands.”
• For information on the bootloader commands, see Appendix A, “IE 3000 Switch Bootloader
Commands.”
• For information on the debug commands, see Appendix B, “IE 3000 Switch Debug Commands.”
• For information on the show platform commands, see Appendix C, “IE 3000 Switch Show Platform
Commands.”
• For more information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command
Summary.
• For task-oriented configuration steps, see the software configuration guide for this release.
In this document, IP refers to IP version 4 (IPv4).
CLI Command Modes
This section describes the CLI command mode structure. Command modes support specific Cisco IOS
commands. For example, the interface interface-id command only works when entered in global
configuration mode.
These are the main command modes for the switch:
• User EXEC
• Privileged EXEC
• Global configuration
• Interface configuration
• Config-vlan
• VLAN configuration
• Line configuration