Cisco IE-3000-8TC Command Reference

2-317
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
show boot
Related Commands
Ta b l e 2-17 show boot Field Descriptions
Field Description
BOOT path-list Displays a semicolon separated list of executable files to try to load and execute when
automatically booting up.
If the BOOT environment variable is not set, the system attempts to load and execute
the first executable image it can find by using a recursive, depth-first search through the
flash file system. In a depth-first search of a directory, each encountered subdirectory
is completely searched before continuing the search in the original directory.
If the BOOT variable is set but the specified images cannot be loaded, the system
attempts to boot up with the first bootable file that it can find in the flash file system.
Config file Displays the filename that Cisco IOS uses to read and write a nonvolatile copy of the
system configuration.
Private Config file Displays the filename that Cisco IOS uses to read and write a nonvolatile copy of the
system configuration.
Enable Break Displays whether a break during booting up is enabled or disabled. If it is set to yes, on,
or 1, you can interrupt the automatic bootup process by pressing the Break key on the
console after the flash file system is initialized.
Manual Boot Displays whether the switch automatically or manually boots up. If it is set to no or 0,
the bootloader attempts to automatically boot up the system. If it is set to anything else,
you must manually boot up the switch from the bootloader mode.
Helper path-list Displays a semicolon separated list of loadable files to dynamically load during the
bootloader initialization. Helper files extend or patch the functionality of the
bootloader.
Auto upgrade Displays whether the switch is set to automatically copy its software version to an
incompatible switch.
NVRAM/Config file buffer size Displays the buffer size that Cisco IOS uses to hold a copy of the configuration file in
memory. The configuration file cannot be larger than the buffer size allocation.
Command Description
boot config-file Specifies the filename that Cisco IOS uses to read and write a nonvolatile
copy of the system configuration.
boot enable-break Enables interrupting the automatic boot process.
boot manual Enables manually booting up the switch during the next bootup cycle.
boot
private-config-file
Specifies the filename that Cisco IOS uses to read and write a nonvolatile
copy of the private configuration.
boot system Specifies the Cisco IOS image to load during the next bootup cycle.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes