Cisco IE-3000-8TC Command Reference

2-29
Cisco IE 3000 Switch Command Reference
OL-13019-01
Chapter 2 IE 3000 Switch Cisco IOS Commands
boot helper-config-file
boot helper-config-file
Use the boot helper-config-file global configuration command to specify the name of the configuration
file to be used by the Cisco IOS helper image. If this is not set, the file specified by the CONFIG_FILE
environment variable is used by all versions of Cisco IOS that are loaded. Use the no form of this
command to return to the default setting.
boot helper-config-file filesystem:/file-url
no boot helper-config file
Syntax Description
Defaults No helper configuration file is specified.
Command Modes Global configuration
Command History
Usage Guidelines This variable is used only for internal development and testing.
Filenames and directory names are case sensitive.
This command changes the setting of the HELPER_CONFIG_FILE environment variable. For more
information, see
Appendix A, “IE 3000 Switch Bootloader Commands.”
Related Commands
filesystem: Alias for a flash file system. Use flash: for the system board flash
device.
/file-url The path (directory) and helper configuration file to load.
Release Modification
12.2(44)EX This command was introduced.
Command Description
show boot Displays the settings of the boot environment variables.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes